Skip navigation
bluzdawg
bluzdawg
Currently Being Moderated

Changing Sequence Settings OR....

Nov 17, 2012 11:51 AM

I now have 2 1/2 hours of footage trimmed to about 30 min ( the project i need to submt), and now am beginning 

to comb through the sequence doing some final touches,  and the first one was a clip getting stabilized, at which point

I was faced with " "warp stabilizer requires clip dimensions to match sequence"   Then I discover that my entire sequence

is set to 1440X1080, rather than 1920X1080.   I HOPE that there is some way to rescue this with OUT having to

do it all over.  Anyone?.  

613 Views   4 Replies   Latest reply: Jim Simon, Nov 17, 2012 6:56 PM
 
Replies
  • Harm Millaard
    Currently Being Moderated
    1. Harm Millaard,
    Nov 17, 2012 12:08 PM   in reply to bluzdawg
    Report

    Import the project/sequence into a new project with the correct settings.

     
    |
    Mark as:
  • bluzdawg
    Currently Being Moderated
    2. bluzdawg,
    Nov 17, 2012 12:27 PM   in reply to Harm Millaard
    Report

    ok, i click new item, select sequence, make sure it's 1920x1080, and import...is where i get stuck

     

    I can find the project, but what imports is NOT as expected - I DID have a crash just before

     

    i discovered the erroneus sequence setting and that may be affecting what i had hoped to

     

    import -  or am i going about this the wrong way?

     
    |
    Mark as:
  • bluzdawg
    Currently Being Moderated
    3. bluzdawg,
    Nov 17, 2012 12:50 PM   in reply to bluzdawg
    Report

    and now...i seemed to have solved the issue -  i opened the new sequence on the timeline after lassooing

     

    and copying the entire sequence. audio and title track and simply Ctr-V pasting it all onto the new

     

    timeline.    - and find that warp or whatever effects seem to works just fine.     Not sure that's the way

     

    to do it, but it seems to have worked this time....

     
    |
    Mark as:
  • Jim Simon
    Currently Being Moderated
    4. Jim Simon,
    Nov 17, 2012 6:56 PM   in reply to bluzdawg
    Report

    i had hoped to import -  or am i going about this the wrong way?

     

    Importing is the wrong way.

     

    Stay in the same project and create the new sequence with the proper settings.  Then just Copy/Paste all the clips into it.

     
    |
    Mark as:
Actions

More Like This

  • Retrieving data ...

Bookmarked By (0)

Answers + Points = Status

  • 10 points awarded for Correct Answers
  • 5 points awarded for Helpful Answers
  • 10,000+ points
  • 1,001-10,000 points
  • 501-1,000 points
  • 5-500 points