Copy link to clipboard
Copied
I made some browse sequences in my project. In Webhelp I selected those browse sequences en enabled them to be generated.
The browse buttons are shown in the output toolbar but not de names of de browse sequences.
What must I do to make them visible?
Copy link to clipboard
Copied
Hi there
Unfortunately the names of the browse sequences have never been visible. At least, not that I've ever seen. The only times I've ever seen the names of the sequences is when using a compiled CHM file.
There is no way I"m aware of to make the sequence names visible. For starters, if this were an option, where would you expect the sequence name to be presented?
Cheers... Rick
Copy link to clipboard
Copied
Yet in preview of the different skins the names are shown.
If that is not possible, the browse sequences are unfortunately not very useful.
Thanks for your answer though
Copy link to clipboard
Copied
That is not a browse sequence, it is a Content Category as set up in Dynamic User Centric Content.
See www.grainge.org for RoboHelp and Authoring tips
Message was edited by Peter Grainge to correct typo.
Copy link to clipboard
Copied
Ah, OK, thanks