Skip navigation
Gray Susan
Gray Susan
Currently Being Moderated

Only last slide showing when recording a Software Simulation in CP5

Mar 7, 2012 8:30 AM

I'm working on a series of lessons about a database application.  I've recorded 3 lessons with no problems.  Of course today is different.  I've set CP5 up to record a new set of screens and when I finish recording only the last slide is showing up on the filmstrip.  I've checked and it isn't on FMR.  Any ideas.  I've ran through the simulation 3 times making sure I've clicked somewhere on each screen I want it to capture and no luck.

Thanks for any and all help.

Susan

326 Views   2 Replies   Latest reply: Gray Susan, Mar 9, 2012 7:59 AM
 
Replies
  • RodWard
    Currently Being Moderated
    1. RodWard,
    Mar 7, 2012 6:23 PM   in reply to Gray Susan
    Report

    When recording the simulation, are you able to hear the Captivate "camera shutter" sound each time you click?  If not, does this shutter sound occur if you do a manual capture using the key assigned in your preference settings?

     
    |
    Mark as:
  • Gray Susan
    Currently Being Moderated
    2. Gray Susan,
    Mar 9, 2012 7:59 AM   in reply to RodWard
    Report

    I have the sound turned down since I work in a cubical.

    The problem resolved when I rebooted the computer.

    Thanks

     

    Susan Wright (Equilady)

    Remember, the mighty oak was just a nut that held its ground.

    http://www.equilady.com

     
    |
    Mark as:
Actions

More Like This

  • Retrieving data ...

Bookmarked By (0)

Answers + Points = Status

  • 10 points awarded for Correct Answers
  • 5 points awarded for Helpful Answers
  • 10,000+ points
  • 1,001-10,000 points
  • 501-1,000 points
  • 5-500 points