Adobe Community: Message List - RoboHelp 10 - Table Preferred Column Width Issue

Re: RoboHelp 10 - Table Preferred Column Width Issue

forums_noreply@adobe.com — Wed, 12 Nov 2014 18:39:46 GMT

The table is not set to 100%. When I set it to 100%, there is no change in behavior.

Re: RoboHelp 10 - Table Preferred Column Width Issue

forums_noreply@adobe.com — Sun, 09 Nov 2014 12:20:57 GMT

Check the table is set to 100% and the columns add to that.

See www.grainge.org for RoboHelp and Authoring tips

@petergrainge

RoboHelp 10 - Table Preferred Column Width Issue

forums_noreply@adobe.com — Tue, 04 Nov 2014 20:55:55 GMT

I converted a RoboHelp 9 project to RoboHelp 10 and noticed that Column 1 in all tables has a preferred width setting of 93% and it is not allowing me to remove this setting. When I uncheck the Preferred width checkbox and click OK, then go back to the Table Properties>Column tab, the Preferred width checkbox is checked again with a width setting of 93%. The column width is not specified in the HTML, it is set to fit to the contents (<col />). The odd thing is that Column 1 only displays this way in Design view. When previewing and publishing the topic, it displays correctly (fits to contents). This however makes editing content in tables extremely difficult in Design view. Any assistance is appreciated.