-
1. Re: Having Trouble with 5.1 Output with the New SurCode Codec in PPro CC
S Kendall Nov 9, 2013 10:10 AM (in response to S Kendall)SOLUTION
Sorry, I feel dumb. I figured out what my problem was. I had created the sequence as a stereo sequence rather than 5.1. Once I changed that, everything worked fine.
Hopefully if someone else makes the same mistake this post will help them out.
Maybe someone could explain some of the settings for the SurCode Codec, though. For instance, I have no idead what "Primary Level" means. Or what I should set the dialog level to (I just guessed -12 because that's usually what I like dialog to be around).
Some tips on these settings would be greatly appreciated. I found this page on Minnetonka's website, but it doesn't have a manual for this version of the codec (at least not that I could find): http://minnetonkaaudio.com/index.php?option=com_content&view=article&id=61&Itemid=66http:/ /
-
2. Re: Having Trouble with 5.1 Output with the New SurCode Codec in PPro CC
S Kendall Nov 9, 2013 10:15 AM (in response to S Kendall)After a little more searching, I found this page on Minnetonka's website: http://www.minnetonkaaudio.com/index.php?option=com_content&view=article&id=82&Itemid=98
This does go into more detail about the SurCode Codec for Premiere Pro CC. I'll read this, but if any of the experts out there have some more info they'd like to add, please do.
-
3. Re: Having Trouble with 5.1 Output with the New SurCode Codec in PPro CC
Richard M Knight Nov 9, 2013 1:19 PM (in response to S Kendall)For dialogue peaking between -12 and -6 try setting the dianorm level to -23, -12 will be too quiet. You could use the new loudness radar in CC to measure the exact loudness. I'm not in front of my editing pc so I can't remember the exact numbers but the data rate for dvd should not be the default 660 ish. The 440 figure is the highest you can use. Bluray can use the higher figure.
TC Electronics provide the Loudness Radar plug-in have a look at http://www.tcelectronic.com/loudness/




