-
1. Re: I set all audio gain too low - any way to up it for an entire project quickly?
Richard M Knight Feb 13, 2014 4:40 AM (in response to ricardo_lacombe)Lots of ways,
Add a volume effect to the master fader in the track mixer.
The one I would use would be a dynamics effect, added, once again in the effects section of the master fader. Use the gain make-up control in the compressor to make it louder and set the limiter control to -2db to catch any peaks.
-
2. Re: I set all audio gain too low - any way to up it for an entire project quickly?
ricardo_lacombe Feb 13, 2014 5:15 AM (in response to Richard M Knight)That's awesome. Thanks for the advice.
-
3. Re: I set all audio gain too low - any way to up it for an entire project quickly?
JSS1138 Feb 13, 2014 4:08 PM (in response to ricardo_lacombe)You can select all the clips and use the [ and ] keys to adjust the volume as needed. This will keep the relative levels consistent.
You can also select them all and apply the same Gain adjustment, which will also keep the relative levels.
-
4. Re: I set all audio gain too low - any way to up it for an entire project quickly?
ricardo_lacombe Feb 15, 2014 4:27 AM (in response to Richard M Knight)Sorry....how do I add an effect to the actual Master track? There's no clips on the Master track in the timeline to add effect to, and I cannot see where I could do this from, say, the audio mixer.



