4 Replies Latest reply: Oct 27, 2014 10:04 AM by msrusnak

Pending State... for a day

msrusnak Oct 27, 2014 8:04 AM

I have an H.264 Blue Ray file I have exported from Premiere that is 22G. When I try to build the disc I keep getting an error about how it is in "pending state". I happened to have to do something and just left the program going thinking Encore just needed to do it's thing but that's been a day now and I still get the some message. Any ideas?

1. Re: Pending State... for a day

Stan Jones Oct 27, 2014 8:36 AM (in response to msrusnak)

What does Encore show in the project panel under the Blu-ray Transcode Status when you imported the file? Do not transcode? Not transcoded?

It is important to know whether the build is including a transcode, or just the other parts of the build.
Like Show 0 Likes (0)

Actions
2. Re: Pending State... for a day

msrusnak Oct 27, 2014 9:17 AM (in response to Stan Jones)

Untranscoded
Like Show 0 Likes (0)

Actions
3. Re: Pending State... for a day

Stan Jones Oct 27, 2014 9:54 AM (in response to msrusnak)

If exported as H.264 Bluray, you should use settings that allow it to show as "Do Not Transcode." The file may be a bit too big, depending on what else you have in the project.

Unrelated to that, it helps troubleshooting to use the "transcode now" option to separate problems with transcoding the asset from other issues in the project.
Like Show 0 Likes (0)

Actions
4. Re: Pending State... for a day

msrusnak Oct 27, 2014 10:04 AM (in response to Stan Jones)

In between our emails I seem to have figured out how to burn to the disc but I think my issue now is that I'm not finalizing the disc. Do oyu know how to do that in Encore?
Like Show 0 Likes (0)

Actions

Go to original post

Legend

Correct Answers - 10 points