This content has been marked as final. Show 5 replies
I'm using DW 8, by the way
Can you send us a link to the page so we can see what is up?
> I am using a table to make a LONG page on my website
"Dreamweaver 8 does not fully render large files in Design view on Macintosh
When you open certain large files in Design view in Dreamweaver 8 on the
Macintosh, Dreamweaver does not render the complete page. This typically
causes the last section of the page to be cut off. This issue does not occur
in earlier versions of Dreamweaver.
The size limit is not the number of bytes in the source file, but the
display size to which the markup renders. Dreamweaver 8 currently has a
limitation of 32,768 pixels by 32,768 pixels on the Macintosh. (Ref. 201845)
The Dreamweaver engineering team is researching this issue. Below, find two
workarounds for this issue:
* Change the Set Magnification pop-up menu in the lower right corner of
the Document window to 99% or 101%. You can type these values directly into
the Set Magnification pop-up menu.
* If possible, break your page into smaller pieces over multiple files.
Last Update: 09-19-2006
Permanent Link: http://www.adobe.com/go/54f19ec2
Adobe Community Expert, dreamweaver
Thanks so much for the quick help... I set the zoom to 99% and can see what I'm doing again!
Are there any other work-arounds or fixes?
changing the zoom worked for a while, but now the page is longer and I'm having the same problem.
Would upgrading to Adobe Dreamweaver CS3 fix this problem for good?