-
1. Re: Why isn't my icc profile in the "other" tab in the color management tab in the Print module?
trshaner May 7, 2015 12:06 PM (in response to WSheehey)1 person found this helpfulIt's probably a CMYK color profile. What is it?
-
2. Re: Why isn't my icc profile in the "other" tab in the color management tab in the Print module?
WSheehey May 7, 2015 12:08 PM (in response to WSheehey)I just figured it out, and I'll put the answer here in case others run into the same issue.
I closed out of the Print module and went into the Develop module. I went into soft proofing mode (shortcut "S") and looked on that Color Management-Profile-Other list and there it was. I then closed out of soft proofing and went back to the Print module. Now the icc profile was listed. Strange behavior, but there you go.
-
3. Re: Why isn't my icc profile in the "other" tab in the color management tab in the Print module?
WSheehey May 7, 2015 12:09 PM (in response to trshaner)No, it was RGB.
-
4. Re: Why isn't my icc profile in the "other" tab in the color management tab in the Print module?
trshaner May 7, 2015 3:41 PM (in response to WSheehey)WSheehey wrote:
I just figured it out, and I'll put the answer here in case others run into the same issue.
I closed out of the Print module and went into the Develop module. I went into soft proofing mode (shortcut "S") and looked on that Color Management-Profile-Other list and there it was. I then closed out of soft proofing and went back to the Print module. Now the icc profile was listed. Strange behavior, but there you go.
When adding profiles, presets, plugins, or updating your monitor's calibration profile you should close LR and then relaunch it so the updates are loaded into LR. As you've discovered closing out certain modules does the same thing, but I'd suggest relaunching LR.
-
5. Re: Why isn't my icc profile in the "other" tab in the color management tab in the Print module?
WSheehey May 17, 2015 2:21 PM (in response to trshaner)Yes, I did that. I closed out of LR, restarted the computer and re-launched LR 2 or 3 times to no avail. It only showed up after I switched modules and looked in the ICC profiles listed in Develop.