Does anyone know if there's any way to change the default size of the preview window - I find it much easier to do fine trimming when it's bigger, and it's something of a hassle to have to enlarge it every time it pops up.
i apologize if the answer's obvious, but I couldn't find it.
Welcome to the forum.
What version of PrE are you using?
I have Show Docking Headers selected under the Window drop-down in the Toolbar, and when I resize, close, then re-launch, my Program Monitor is the same size, that I last had it.
You are correct. If one wanted this for the Source Monitor, they would be out of luck, as its size, and initial location, is hard-coded into the program. I had not thought that was what the OP was asking. Thanks for that clarification.