I was using the Clone Stamp Tool in Expert Editor and then suddenly it was no longer available - It was apparently replaced by the Pattern Stamp Tool. How can I get it back into my group of Expert editor tools?
Oh it is simple. All you need to do is to click on the icon shown in this picture with a red box:
You are using PSE11 Right? If not post back with your correct version but the principle is the same; method slightly different.
If you are in PSE10 then you need to right-click on the Clone Stamp Tool Icon and then you will see something like this:
Now you should know what to do from here.
Good luck but always post back with further questions and/or comments.
I have PSE11. However, this did help me to look in the same place as the Pattern Stamp tool where I found the Clone stamp tool. Thank you lots for your response
Got it!!!! Thank so much.
Retrieving data ...