What, if any effects have you applied to the clips in question?
Three Way Color Correction...
I think I adjusted the black input level to cause it to clip? I tried adjusting that back to normal the only problem is I can't tell what fixes it until I render it, not sure how to render just one clip...?
EDIT: These are my new revised settings, before this I had the black input level raised a bit, hopefully this will fix it just don't know how to render just one clip to check without waiting 2 hours for the whole video....
EDIT-2: I think I found out how, just make the work area to only that clip and then render effects in work area... lets test this out...
Yup just did now that its showing that its normal when I "render work area effects" even with the settings I had before but when I final render it, it comes out green...? What's going on?! My anxiety is through the roof.
What are your Export Settings?
Same as always, it can't be that cause it's only on these two camera angles of the whole video.
Checkboxes Export Video and Export Audio
Basic Video Settings:
Frame Rate: 23.976
Aspect: Square Pixels (1.0)
TV Standard: NTSC
Checkbox Render at Maximum Depth
Bitrate Encoding: VBR, 2 pass
Target Bitrate [Mbps]: 10
Maximum Bitrate [Mbps]: 40
Checkboxes Use Maximum Render Quality and Use Previews
Basic Audio Settings
Audio Codec: AAC
Sample Rate: 48000 Hz
Audio Quality: High
Bitrate [kbps]: 320
Try unchecking the Max Bit Depth box. This happened to me once and unchecking that box made it go away. It happened once on a clip that wasn't over or under exposed or anything. Just totally random part of the same clip in a much bigger project. Interestingly it was on a woman's hair as well. As a result of this issue, I never check that box anymore. Good luck!