I did a couple searches and couldn't find a discussion addressing this issue -- apologies if it's been brought up recently.
I am learning to edit with the multicam function in CS6, and I was wondering how to make sure the audio and video are connected in the timeline when performing a ripple or roll edit. I have a few seconds of "ummm" that I need to remove, but when I use either tool, only the video is removed, and not the audio.
I looked to make sure both are linked, and it says that they are. Any suggestions on how to make sure I can fine tune my multicam sequence in the timeline and make sure it edits both the audio and video at once?
When audio and video are linked, adjusting one will also adjust the other by default. I suspect some sort of operator or observer error here, but it's tough to know exactly where without seeing what you see. Post a screen shot or two.