Is there a way to assign a button action only when the playbacket is on:
i.e. lable "play3"on timeline instead of placing a hotspot over each button with code?
Basically an active and inactive state.
button1 exists on entire 30 seconds then only active when playbacket hits and stops on "play1", "play2", "play3" etc..
Branched this discussion to a new thread.
Yes, you can do this with a little bit of code. Take a look at the "state management" section in this blog post, which will describe how to set variables, get variables, and use an if statement to code some logic in.
Hope this helps,