6 Replies Latest reply on May 18, 2014 2:52 PM by colinhar

    Bleed problem

    colinhar

      InDesign 5.5. I'm laying out a magazine which has a pair of horizonal lines going the full width of the paper on the editorial page. The fore (outer) edge has a 5 mm bleed. The layout looks fine in InDesign but when the pdf is produced the lines are about 5 mm short on the binding edge, leaving a white gap, and worse; the lines extend about 5 mm onto the previous page. The fore edge is OK. Any suggestions as to what is happening?