0 Replies Latest reply on May 8, 2007 10:50 PM by OniLink

    Number Stepper

    OniLink
      I set this number stepper to have a minimum of 1 and a step size of 1. But when I go to step up, instead of going to 2, it goes to 11, then 111, then 1111, etc.

      Why is it doing this? It's as if it only accepts 1's... because when I try and enter a '2', it goes blank.

      Thanks for any help,
      ~Oni.

      ** EDIT: I found the problem to be that I hadn't defined the maximum correctly **