Thanx for your reply. I've tried that. But somehow it isn't working. Do you have any experience using that? Here's the content of my .mrk file:
Is this ok?
I never had much luck with that either...
Changing the offset is easy, though, so why not just leave the length alone and use an odd-value offset? You might need to go to perhaps a 10mm total Length + Offset instead of 5, though. Would that be a deal breaker?
It's that simple :-) Just print instead of export and it works. Thanx! I will use this till I've figured out how Eugenes solution works.
Adjusting the offset in the export dialog should work fine. My printer likes to have an even half or three-eighths inch around PDFs, and I have custom presets for both.