3 Replies Latest reply on Jun 1, 2006 1:23 PM by PeterDeMan

    Director MX communications via Comm 1

    TJB5
      I'm looking for a canned Xtra program/module that will allow me to communicate over the COMM1 channel of my PC from Director. I need to control several stepper motors by sending ascii command strings via the COMM Channel.

      I've seen some very old (2003)postings hinting about something in existence but have been unsuccessful in finding.
      If need be I'll write a C++ program to do this but would rather not waste the time if something already exists.

      Thanks.
      TJB5