2 Replies Latest reply on Jul 26, 2017 2:27 PM by Jack

    Clone Stamp Tool Lays Down 'Diluted' Content

    Jack Level 1

      I don't know how else to describe this, but for some reason the clone stamp tool has gone into a state, in which it is painting source content into the target, diluted about 1/5 in strength, requiring me to repeat each clone-stamp stroke 5-6 times before getting the desired density of content on the target area.

       

      If one of you would point me to the control where this property is being set (I assume that I inadvertently adjusted this?), I would be grateful