Cannot understand the sketch. Do you want to send a line below another layer?
Use multiple blend mode on your top layers.
1 person found this helpful
As I remember it, we used to show an unlinked crossover like this
If you want to put a small break in a line to show where another line crosses but does not link to it, then add a layer mast > Make a selection around the line (red arrow) and fill the selection with black (red circle)
Are we getting close to your issue, or still miles out?
Thanks Trevor.. I think I am gonna need that jumper line too. How do you draw it?
As for the example above, layer 1 is an enclosure line, and layers 2 and 3 are drain lines going from one enclosure valve into a pump enclosure, so I am not drawing a jumper on those.