This content has been marked as final. Show 5 replies
Is this for .CHM or WebHelp? If it's WebHelp, you need some images. You may obtain some by clicking here.
If it's for compiled .CHM, you need to look at the Single Source Layout properties. Click the Advanced... button, then the TOC Styles tab. Click to enable Lines from Root, then you will be able to choose Plus/Minus Squares.
Hope this helps a smidge... Rick
Thanks for your reply. It's compiled Help, .chm. I neglected to mention that I'm working with an ancient version of RH, SO ancient, in fact, that I may be beyond the reach of this forum. I'm running RoboHelp 9.1, as in eHelp's 2001 RH 9.1.
Rick, in my version, the controls that you are speaking of don't exist. : ) ...other ideas?
I found it. I'm well familiar with the TOC/Project Settings tabs but didn't originally see the Plus/Minus Squares checkbox. Actually, it was inactive. I could only activate it when certain other settings were enabled as well. Anyway, it's fixed. Thanks so much for your help!