2 Replies Latest reply on Aug 20, 2008 9:29 AM by (mike123)

    align layout of workflow in workbench

    Level 1
      Hi,
      I have a workflow that is quit big, more then 100 components, with a lot of gateways, branches etc. I was trying to adjust the layout of the components and save it. The next time when I reopen it, the layout went back to the previous layout. The adjusted layout was not saved. Why y y y? Any configuration to set.

      I have Service pack 2 installed. It seem that with small workflow,there is no such problem. But when workflow get complex, Live cycle cannot handle? Occanionally, there is problem when dragging component to workflow. Have to close the workflow and reopen to solve the problem.

      Thanks.