14 Replies Latest reply on Aug 1, 2007 11:44 AM by (Howard_Cromwell)

    Vista, IEEE and offline Camcorder in PP CS3

      I am unable to get PP CS3 to see my camcorders (GVD-1000 and DCR-PC9). When I turn them on, Vista sees them and will capture fine but if I say take no action or any variation there of, my PP CS3 will not take control of the devices. This after selecting the specific setup (GVD-1000 etc) or standard. Did the re-boot and same test. Set Vista to default to take no action when device comes up with the same results.

      I can capture in Vista but don't have the controls/clip that I should have with PP CS3.

      Anyone else having this problem? Anyone fixed it if they did?

      V/r
      Bob