This content has been marked as final. Show 3 replies
You may have a small clip, almost invisible at the end of the timeline. In any case setup your Work area bar over the 59 seconds and export "Work area Bar" instead of "Entire Sequence". You will find this under "Settings" after you use the Export Command.
Hello Pierre !
Well, I thank you VERY much for replying this morning !
I just checked, and sure enough I had a tiny tiny "title" sitting
at the end of the time line !, it was so small that I couldn't see it until I zoomed in !
you made my day better, I thank you again !
and thank you for the tip on the exporting option.
Better than setting the Work Area (if only because once set manually, you can't get it back to automatic), is hitting the End key. It should place the CTI to where you expect it. If there's anything unseen after where the end should be, it'll go there instead.1 person found this helpful