I think somewhere I messed up the sequence settings and/or dont have a full understanding of what settings are usually used. What I tried to do was export a media file (targa) and the export menu said the source is 1920x1200 and the output is 1280x720. So when I export the targa file and re-insert the still image into my project, the size is very small compared to the source. Is there any way I can change this? Also when I am fully done is 1920x1200 too big? What resolution should I be using?
You should export at the same resolution as the original media.
The export setting for resolution is greyed out at the default output resolution which is different than the resolution that was put in the sequence settings. Not sure how I can change that.
Ah...Found out that if I switched it to Full HD Targa file then it would update to the correct output resolution. It was on default before...interesting.