8 Replies Latest reply on May 20, 2010 2:16 AM by Jacob Bugge

    Issues with drawing a parallelogram




      I am trying to make something but having difficulties..


      I want the corners of my shape to be rounded, so I start with a rounded rectangle.


      I drew the shape then right clicked on it and selected "Shear". I chose a 45 degree angle which has done the job ok. The shape is fine!


      The tricky part - It is to be made of two colours (two triangles made by cutting from the top, down to the bottom of the parallelogram)


      The problem is:


      I want a light border around the sides of the shape and in the middle where it divides.


      I tried using the pen tool to draw around the inner bit but cant get it to draw perfectly, always bits that I miss or dont do right.



      Any easier way to do this?