3 Replies Latest reply: Jun 29, 2010 9:51 AM by Bill Hunt RSS

    Project cannot render again due to disk drive name change

    ANTHONY THOMAS Community Member

      Recently I installed a new motherboard and processor. When I came back up my drives all have different labels, except for the C: drive. My encore project which rendered successfully before now gets this error in the middle of rendering and burning to bluray.

       

      Blu-ray Error "device not ready", code: "3", note: "File cannot open. (G:\encorework\sequence 9-10-11\AuthorScriptHDMVSessions\Silence.ac3.11_29_50_18.3.2010_UTC_04_00DST.ves) - ERROR: Error locating.

       

      The new drive is M and no longer G. When I go into encore and check the project all looks well. What file is still looking on G: ?