-
1. Re: Need help to wrap label around cylinder
Wade_Zimmerman Jul 16, 2010 10:43 PM (in response to emilycornfield) -
2. Re: Need help to wrap label around cylinder
Wade_Zimmerman Jul 17, 2010 2:58 PM (in response to Wade_Zimmerman)I am posting this on the forum in response for a step by step in a private message. Private messages are finebut someone else might need this just to get them started using the 3D features.
-
3. Re: Need help to wrap label around cylinder
emilycornfield Jul 17, 2010 3:07 PM (in response to Wade_Zimmerman)Thanks so much Wade. I'll upgrade to 5 as I can't figure out how to do it in CS3. But as I do a lot of these bottles it'll be worth it. This is just great!
-
4. Re: Need help to wrap label around cylinder
emilycornfield Jul 17, 2010 3:43 PM (in response to Wade_Zimmerman)One last thing - do I need CS5 extended for this feature or does CS5 standard offer it?
Thanks again!
-
5. Re: Need help to wrap label around cylinder
Wade_Zimmerman Jul 17, 2010 8:16 PM (in response to emilycornfield) -
6. Re: Need help to wrap label around cylinder
davetwo Jul 19, 2010 12:41 AM (in response to emilycornfield)There is not a magic button for this. But you can achieve it quite easily in a few steps - and record an action for it so you only have to do it once.
1. Crop off half the label, leaving only the part that will be visible on the front of the flask.
2. Go to Filter>Distort>Sphereize. Horizontal only. 95%
3. Free Transform to fit. Then Transform>Warp>Arch Lower to get the perspective.






