3 Replies Latest reply on Sep 6, 2010 12:20 PM by naartjie gello

    How to make the CTI respond to the work area again?

    robert_ro Level 1

      Hello,

       

      i suddenly have a unusual problem (4 me). I  work on a project and i noticed today that the CTI dose not  act according to my work area when i RAM preview. After pressing 0 it just  goes after the end of the work area continuing to render

      Capture.PNG. (green line)

       

      And also it does not start to render at the  beginning of the work area.  It uses somehow the comp's lenght...

       

      Please advise.

       

      Thanks!

       

       

      I attached a photo so you can see what is it about.