1 Reply Latest reply on Mar 19, 2011 7:33 AM by Steve Grisetti

    Rendering PRE3 project in PRE9

    Capperdog

      Hi, just purchased pre9 for my new pc and wanted to finish editing a pre3 project. Loaded complete folder of old pre3 project and opened it in pre9. All looked fine, it runs, I can do my changes but it will not render anything other than the changes and the usual red bar stays on everywhere else. Did try reloading the whole project folder again and now notice the unrender(?) bar is present from start and will not render.  Any ideas please :-)

        • 1. Re: Rendering PRE3 project in PRE9
          Steve Grisetti Adobe Community Professional

          In my books, I very much recommend against opening an old version project in a newer version of the program. IT nearly always leads to some kind of buggy behavior.

           

          And that leap from version 3 to version 9 is a particularly big one!

           

          I very much recommend you finish the version 3 project in version 3 and then start a new project in version 9. Otherwise, there's probably no way to fix these kinds of issues. Sorry.