0 Replies Latest reply on Jan 2, 2012 4:32 PM by specialkbreak

    Selection outline in Transform Again

    specialkbreak Level 1

      I work with detailed masks that I rotate around the center using the Transform Again command on a selection. This leaves me with  one layer and one mask which is what I am looking for. However, I have found that the outline of the selection outline (marquee or lasso) shows up as a pixel wide gap in the mask for each rotation. I then have to go over my mask with a brush to clean up these lines.

      I have tried feathering the mask and that hasn't worked. I welcome suggestions.